CV 90/35-DK

CV 90/35: Infantry Fighting Vehicle

Statistics

Main Gun: ATK Bushmaster III 35mm Autocannon
Ammunition Stowage: 70 ready/140 stowed
Ammunition Caliber: 35 x 228mm
Default Ammunition: 35/70 NMxxx APFSDS, 35/70 ABM (KETF)

Coaxial Machine Gun:
Ammunition Stowage: 250 ready/1550 stowed
Default Ammunition: 250/1550 7.62mm AP (NATO)

Grenades: HE Grenades
Ammunition Stowage: 2 ready/2 stowed
Default Ammunition: 2/2 HE Grenades

Grenades: Smoke Grenades
Ammunition Storage: 8 salvo ready/8 stowed
Default Ammunition: (Left) 3/3 Smoke*, (Right) 3/3 Smoke*, (Front) 2/2 Smoke*

• Only 3 salvos of smoke should be available, it is suggested that only 1 be allowed on each arc in the scenario editor.
  

Armour Protection:
Front Turret: Protected from 30 mm AP
Front Hull: Protected from 30mm AP
Equipped with spall liners

Combat Mass: 31.75t
Engine Power: 755hp Scania DI 16 Diesel
Height: 2.8m
Top Speed: 70kph

General

The dismount section for the CV 90/35 DK is 6 men (compared to 8 men in the CV 90/40-B), carrying M136 (AT-4) light anti-armour weapons.

Similar to the Pizarro, the CV 90/35 DK features an "end-of-belt" stop to avoid firing too many rounds, greatly increasing the required time for subsequent reloading. This stop kicks in when 21 rounds are left. To override, press the button map to the (by default unassigned) 'override end-of-belt stop' command.

To reload, turn the turret to the 9 o'clock position and elevate the barrel slightly. The TC should confirm the correct positioning with the 'On' command.

Thermal Signature

Squad

• To access the squad peri and the VIS screen go to the commander's position (F7); while the squad leader is mounted in the CV9035 you can also access some views of the CV9035 itself from the F7 position:

F4 will take you to the CV9035 squad peri

• Alt+F1 is the rear camera view
• Alt+F2 is the left camera view
• Alt+F3 is the right camera view

For the gunner and commander the VIS screen will display either view; the lower right button on the VIS screen will toggle between the three camera views

As with the VCS screen, press the magnification hot key (N) when the mouse cursor is over the screen and the viewpoint will move much closer to the screen. Pressing N again will toggle the viewpoint back to normal. As with other vehicles, pressing N when the mouse is not over anything special will move the viewpoint forward a bit, and pressing N again will move it back.

• The hot keys Alt+F1, Alt+F2 and Alt+F3 will show the camera views in the full window

The troop leader can now direct the mounted combat by using the “suppress here” and related commands

The dismounting squad of the CV90/35 is now equipped with AT-4 launchers instead of RB57 (rev. 2.448).